Posso usare il motore Xspeed che usavo sulla MR01, anche sullo chassis a 2.4Ghz? o esistono impedimenti per quanto riguarda l'elettronica? GRAZIE

Vai tranquillo, la pcb 2.4Ghz monta di serie 4 fet!!!

Come detto da Hirosaka:27 vai tranquillo con x-speed, però ti consiglio di prendere uno stock-r, la mini-z si trasforma in un missile...Ihihihih...

Caratteristiche del 3004 fet sulla scheda 27Mhz
HAT3004R
Absolute Maximum Ratings (Ta = 25C)
Item Symbol Ratings Unit
Nch Pch
Drain to source voltage VDSS 30 –30 V
Gate to source voltage VGSS 20 20 V
Drain current ID 5.5 –3.5 A
Drain peak current ID(pulse)
Note1 44 –28 A
Body-drain diode reverse drain current IDR 5.5 –3.5 A
Channel dissipation Pch Note2 2 W
Channel dissipation Pch Note3 3 W
Channel temperature Tch 150 C
Storage temperature Tstg –55 to +150 C
Note: 1. PW 10s, duty cycle 1 %
2. 1 Drive operation : When using the glass epoxy board (FR4 40 x 40 x 1.6 mm), PW 10s
3. 2 Drive operation : When using the glass epoxy board (FR4 40 x 40 x 1.6 mm), PW 10s

Caratteristiche del fet sul circuito 2.4 Ghz
HAT3010R
Rev.8, Aug. 2002, page 2 of 14
Absolute Maximum Ratings
(Ta = 25°C)
Item Symbol Ratings Unit
Nch Pch
Drain to source voltage VDSS 60 –60 V
Gate to source voltage VGSS ±20 ±20 V
Drain current ID 6 –5 A
Drain peak current ID(pulse)
Note1 48 –40 A
Body-drain diode reverse drain current IDR 6 –5 A
Channel dissipation Pch Note2 2 2 W
Channel dissipation Pch Note3 3 3 W
Channel temperature Tch 150 150 °C
Storage temperature Tstg –55 to +150 –55 to +150 °C
Notes: 1. PW ≤ 10 μs, duty cycle ≤ 1 %
2. 1 Drive operation ; When using the glass epoxy board (FR4 40 x 40 x 1.6 mm), PW ≤ 10 s
3. 2 Drive operation ; When using the glass epoxy board (FR4 40 x 40 x 1.6 mm), PW ≤ 10 s
dati tecnici dei produttori