Descrizione
Changing roll centres on your X4 has never been easier, rather than undoing the whole screw and having shims flying everywhere, simply loosen the screw, slide the shim plate out, and install the new roll centre shim plate, and re-tighten the screws!
With the success of RC Maker`s Carbon Roll Centre Shim Plates, and the ever-demanding focus on weight distribution and adding additional weight down low on the Mid Motor platform, they decided to produce brass versions in the most common thicknesses used today.
RC Maker suggests to run them both front, and rear. However, if you feel you need more steering, you could replace the front with carbon and leave the rear brass. If you have too much steering and need more rear traction, then you could leave them in the front only, and use carbon in the rear.
Each pack comes with a pair of front and rear (different lengths) identified by the one (front) or two (rear) indents.
Features:
Easy roll centre adjustment
4 Different Thicknesses available for different roll centres (1.5, 2.0, 2.5, 3.0)
3.0mm Set adds 6g of weight at the lowest point of the car
Adds weight at ends of the car to adjust weight bias
Can be used with any brand Chassis plate
CNC Machined from high quality Brass in Australia
Includes:
2x Front 1.5mm Brass Roll Centre Shim Plates
2x Rear 1.5mm Brass Roll Centre Shim Plates
