Descrizione
Our all new AWD Flat Dish wheel is our first foray into the segment.
We wanted to capture the success of our 2WD Speed Dish and apply what we have learned since their release in order to increase performance, reliability and affordability to your AWD wheels.
The Front and rear wheels have a slightly different height outer side wall in order to balance the performance of the car better and allow for the use of our Low Profile tires both front and rear without the need for truing under most conditions.
We recommend starting with our 40 degree front tire, glued to the wheel with full outer sidewall glue and our Low profile 30degree, 11mm tires in the rear, glued to the wheel.
Much like our 2WD wheels, these are made from Fiber Reinforced Nylon and are Acetone safe so they are not only affordable, but also re-usable.
Our favorite thing about the material is that the tires bond MUCH better to the wheel and unglued tires become a thing of the past.
This allows us to run much smaller tires on our AWDs, which yields faster acceleration and better corner speed.
These wheels are also compatible with our new RX608 Double Decimal Wheel Plate Set.
***For the Giulia, these make the car right about 79mm wide in the front and 78 in the rear.
(Yes, much like 10th scale TC's, you want your front slightly wider on an AWD car for more stability, on power steering and less rolling over).
While plates are compatible, most bodies are not wide enough when you install the plates.
However, we use such small tires and the front side wall is taller, so most of the time, all that is needed is the front sidewall glue.
With the Atomic BZ3, the car ends up at about 75mm front and 74mm rear.
